Droplet de-entrainment by inertial impaction on vertical rods in an air-droplet mixture flow

We experimentally investigate the de-entrainment of droplets by inertial impaction on an array of vertical rods in an air-droplet mixture flow. The de-entrainment efficiencies are measured for a single rod, for a single row of rods, and for a multi-row of rods. We investigate the effects of the droplet mass flux (0.5–5.4 kg/m² s), the droplet Weber number (3000–8000), the air velocity (0–6 m/s), the rod geometry, and the surface roughness on the de-entrainment, and the rod diameter-to-pitch ratio effect on the de-entrainment. The results for a single rod show that the de-entrainment efficiency decreases slightly as the droplet mass flux increases; however, in our experimental ranges, there is negligible dependence on the droplet Weber number, the air velocity, and the surface roughness. The rod geometry affects the de-entrainment efficiency. The results for a single row of rods show that the existence of neighboring rods promotes de-entrainment due to droplet splashing, and we develop a correlation to show the effect of diameter-to-pitch ratio on the de-entrainment. Using information on the de-entrainment efficiencies of a single rod and those of a single row of rods, we propose a correlation that predicts the de-entrainment efficiency for a multi-row of rods with a staggered array. The RMS errors of the correlation from the de-entrainment efficiencies experimentally obtained are within 13.5%.     

自锁式景观砌块加筋挡土结构的设计与应用

介绍砌块仿花岗岩挡土结构的特点和砌块形状,针对砌块挡土结构在我国刚开始应用,没有设计、施工规范的现状,依托可以借鉴的加筋挡土结构和浆砌块石挡土结构设计规范,提出了自锁式砌块加筋挡土结构设计中的地面荷载强度及土压力计算方法、砌块层间稳定验算方法、加筋长度和间距验算方法、挡土结构整体稳定验算方法和施工过程中需要注意的主要问题,为自锁式砌块加筋挡土结构设计人员提供了设计验算内容、验算方法和安全系数取值范围,为现场施工和监理人员提供参考,并为该类型的挡土结构推广应用提供技术支持。     

施加复合电磁搅拌对A357合金微观组织的影响

在半固态加工技术中，电磁搅拌是最早应用于制备非枝晶浆料的方法之一，同时也是半固态触变压铸技术最早获得工业应用的重要技术基础之一。采用自行开发的电磁搅拌器，研究了多种不同电磁搅拌方式在不同工艺条件下，单独施加或复合施加对A357合金微观组织的影响。试验结果表明：单一施加旋转感应电磁搅拌时，浆料径向组织很不均匀；单一施加无芯感应电磁搅拌。当搅拌电流较小时，径向组织也不均匀，增大电流，浆料质量有明显改善；采用（旋转感应＋无芯感应）复合电磁场进行复合电磁搅拌时，可在电流较小时获得满意的浆料质量。     

圩区排涝模数计算方法研究

合理确定圩区排涝模数对于降低涝灾损失有重要意义。圩区内土地利用性质的不同,会导致产汇流机制和排涝标准的不同,但排涝模数的计算方法基本一致。本文根据圩区下垫面条件进行产汇流计算,入河流量扣除滞蓄量得到排涝模数,充分考虑到圩内河道的调蓄作用。以常熟市为例,对城镇圩区、农业圩区排涝模数进行计算,并分析了两种圩区不同的排涝要求对排涝模数计算方法的影响。     

船艇电站仿真与综合管理系统

论文介绍了船艇电站模拟器的组成和实时仿真功能,着重描述了多层次的图形管理系统及其仿真界面。课题将多媒体课件制作与模拟器有机地结合,涵盖了船舶主要电气设备的控制电路,既利于实践训练又便于原理的讲解,并在实践中取得了良好的效果。     

侧槽溢洪道出口控制水深计算

本文推导侧槽段的总水头损失公式,从而求得侧槽末端的断面能量和水深,并以此水深做为侧槽的控制水深.根据水工模型试验资料验证,本文提出的计算方法是可行的.     

Characterization of Al-doped n-type ZnSe prepared under a zinc-rich growth condition by low-pressure organometallic chemical vapor deposition

High conductivity n-type ZnSe with = 0.01 ωcm and n = 2.4 × 10¹⁸ cm⁻³ is obtained on (100) GaAs substrates by low pressure organometallic chemical vapor deposition. The 14 meV full width at half maximum of the 77 K photoluminescence near-band-edge emission shows a high quality of as-grown Al-doped ZnSe epilayers. With a suitable Al doping level, a strong photoluminescence intensity of near-band-edge emission is obtained. The behavior of near-band-edge emission and of self-activated emission related to the incorporation of aluminum are discussed in this paper.     

Experimental observations on flow characteristics in an open two-phase natural circulation loop

The flow behavior in an open two-phase natural circulation loop was studied experimentally using Freon-113. The heat flux, inlet- and exit-restrictions, liquid charging level and inlet subcooling were taken as parameters. As a result, three basic circulation modes were observed with variation of the heat flux: periodic circulation (A), continuous circulation, and periodic circulation (B). Of these modes, only the continuous circulation mode was stable and the maximum circulation rate appeared with this mode. An increase in the inlet-restriction and/or decrease in the exit-restriction broadened the range of the continuous circulation mode and stabilized the system. When the liquid charging level was lowered or the inlet subcooling was decreased, the continuous circulation mode started at a lower heat flux and the system became stable. The results are summarized on instability maps in the plane of heat flux vs. inlet subcooling.     

三维频率复用环境中的信道偏移指配方法

一种新的信道指配法－信道偏移指配方法正受到越来越多的重视，这种方法能在现有的频率资源条件下，较大地提高移动通信系统的容量。本文主要讨论了三维频率复用环境中的信道偏移指配方法，详细地分析了同频复用和相邻信道使用距离，定量地计量了信道偏移系统的频谱节约效率。本文最后还通过几个实例验证了所提算法的实用性。     

Decision-directed maximum-likelihood estimation of OFDM framesynchronisation offset

The authors propose a method to estimate the synchronisation offset for orthogonal frequency division multiplexing (OFDM) frame alignment without resort to pilot tones. A decision-directed maximum-likelihood estimation of frame synchronisation offset is derived, and the performance of the proposed scheme is confirmed by computer simulation for QAM systems